Top side tension cables - Where do they go??

Anything and everything to do with ascMcLaren cars can go here.
Post Reply
mrheehee
Posts: 51
Joined: Sat Mar 01, 2008 2:39 am
Location: Rome, GA

Top side tension cables - Where do they go??

Post by mrheehee »

My top replacement is coming along nicely but the side tension cables aren't up to being re-used. I see that Henry does not have these, but there are Mustang convertible cables readily available - are they the same or can be modified for our cars?

Also can these be installed later, or do they have to be installed first as the instructions indicate?
Last edited by mrheehee on Sun Apr 29, 2012 3:45 am, edited 1 time in total.
User avatar
Tx Trooperstang
Posts: 103
Joined: Thu Jun 23, 2011 4:19 am
Location: Houston, Tx

Post by Tx Trooperstang »

Even if he does not show them on his site, I would still call him.

Tom
Coming soon # 1079
User avatar
svo413
Posts: 806
Joined: Sun Aug 29, 2004 6:31 pm
Location: San Mateo, California
Contact:

Cables

Post by svo413 »

I got mine from him about 5 years age. They might be simple to fabricate.
Kevin Gold card MCA Judge for Fox Body
85 ASC Vert #612205
88 ASC Vert #542 20,550 miles
84 SVO 24,000 miles, 84 GT Turbo Vert.
03 Mach I, 89 LX Vert, 74 Mustang II
14 CA Special, 69 Mustang coupe, 07 GT500
67 T-bird, 15 F150 Tuscany, 16 F250
mrheehee
Posts: 51
Joined: Sat Mar 01, 2008 2:39 am
Location: Rome, GA

Got 'em....Now where do they go??

Post by mrheehee »

Henry had these and shipped to me fast - like everything else I bought from him!

So here's the story:

I removed my top several years ago, this car hadn't been driven in any weather so I wasn't going to either, and never have. However now it may get caught out in the rain so I have to put a top on it. I bought a new top, also awhile ago and I'm slowly installing it. Without belaboring the point further, it's obvious where the cables attach to the front(number 1 bow) but where to attach them in the back isn't obvious at all. I'm pretty sure it screws down on the rear seal retainer, on the back side. But there aren't any existing holes where it might go.

Can someone have a look at theirs?

Thanks!!
Post Reply