stripe/side body kit installation

n20capri · Post by **n20capri** » Mon Sep 19, 2005 3:31 am

lightning95sc wrote:Mike, have your skirts always had the rivets in them? Neither of my coupes had rivets in the tops of the skirts. That probably would have kept them from warping. Chuck

Me Mike?? Cause mine don't have rivets...it's just those screws inside the door area and the 2 on the ends outide...

tfs2121 · Post by **tfs2121** » Mon Sep 19, 2005 5:27 am

my car has body molding tape under the side skirt in the door area not screws it only has 2 screws one at each end on the outside that go into the body

Sandy · Post by **Sandy** » Mon Sep 19, 2005 2:37 pm

No Screws, fasteners at the ends and tape underneath if the way they left Livonia. To some degee they have all warped in the center. I knew a guy who went to get efforts to attach a brace in the middle, about where the seat's bottom cushion would be, to keep them straight. After 3 years, they had warped a little bit both fore and aft of theunderneath brace.
U__U instead of _U_

Post by **negusm** » Mon Sep 19, 2005 2:43 pm

The body guy on my car used several rivets along the rocker. He put them in the same spot as all the "screws" had previously been. Probably those screws were installed by a previous owner.

-Mike